Once again, we used the reciprocating saw... this time to sever the last segment of pipe from the outlet below the trailer.
While I was cleaning up the area, dad cut a shim to fit that gap in the frame at the top of the counter. I drilled the holes and set it in place.
Door gap fixed!
Test-fitting the vent dome:
I had planned on reusing the screws that I pulled from the roof, but they were quite corroded. I started using the wire wheel on them, but it would have used up too much time, so we made a quick trip to Ace to get new screws. At some point, I might get the old ones cleaned up...
Dicor sealant applied. Hopefully, it's a good seal.
Once the insulation and ceiling panels are in, I'll install the garnish (silly name) to finish this up.
No comments:
Post a Comment